Masimo Radical Signal Extraction Instrukcja Operatora Pobierz pdf (Strona 35)

Radical-7 Signal Extraction Pulse CO-Oximeter Operator’s Manual 3-3

Setup

Monitor Setup

The Radical-7 Pulse CO-Oximeter maintains three types of default values, which the

instrument will automatically revert to after a power cycle:

■ Factory – these options are restored to factory values.

■

Custom – these settings can be changed by the user and retained through the power cycle.

■ Adult / Neo – these settings can be selected to revert to factory or hospital-deﬁ ned

values (for Adult or Neonatal) after a power cycle.

FACTORY DEFAULT SETTINGS

The following outlines the Radical-7 Pulse CO-Oximeter option settings that can be changed

by the user but will revert back to after a power cycle.

OPTION DEFAULT SETTINGS

LCD SCREEN ILLUMINATION

AC Power

Battery Power

Set to maximum, level 5

Set to minimum, level 1

SENSITIVITY

Set to APOD mode

CUSTOM (USER) DEFINED SETTINGS

This mode is indicated by “Mode Custom” on the Alarms menu.

The following table outlines the options that may be changed by the user and that the Radical-7

Pulse CO-Oximeter will remember after a power cycle. The default settings listed below are those

set at the factory and to which the instrument will revert if the user chooses to recall the factory

settings. (see Section 4, Display)

OPTION FACTORY DEFAULT SETTING CONFIGURABLE SETTING

DISPLAY VIEW

Set to Pleth + SigIQ

Pleth + SigIQ, Pleth Only, PVI Pleth

+ SigIQ, PVI Pleth, Numbers

AVERAGING TIME

Set to 8

2, 4, 8, 10, 12, 14, or 16

seconds

FASTSAT

Set to No Yes/No

HOME USE

Set to No Yes/No

INTERFACE ALARMS

SpO

/PULSE RATE

Set to Yes Yes/No

SATSHARE NUMBERS

Set to Yes Yes/No

POWER SAVE

Set to No Yes/No

DATE FORMAT

Set to mm/dd/yy mm/dd/yy and dd/mm/yy

TIME FORMAT

Set to 12 hr 12 or 24 hour

LANGUAGE

Set to English

See Section 4, Display for all

settings

ANALOG OUTPUT

Set to Analog 1: SpO

0-100%

See Section 4, Display for all

settings

Set to Analog 2: Pulse Rate

SERIAL OUTPUT PORT

MODE

Set to ASCII 1

ASCII 1, ASCII 2, Binary,

Philips Vuelink, Spacelabs

Flexport

PULSE BEEP VOLUME

Set to Level 4 Level 1 to 7

ALARM VOLUME

Set to Level 3 Level 1 to 4

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 115 116

Komentarze do niniejszej Instrukcji

Brak uwag

Masimo Radical Signal Extraction Instrukcja Operatora Strona 35

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Masimo Radical Signal Extraction