Masimo Radical Signal Extraction Instrukcja Operatora Pobierz pdf (Strona 105)

Radical-7 Signal Extraction Pulse CO-Oximeter Operator’s Manual 9-1

Service / Maintenance

Introduction

This section covers:

■

How to test the operation of the Radical-7 Pulse CO-Oximeter and the SatShare interface.

■ How to properly clean the Radical-7 Pulse CO-Oximeter.

■ How to recharge and replace the batteries.

■ How to replace the fuses.

■ How to obtain service.

Under normal operation, no internal adjustment or recalibration is required. Safety tests and

internal adjustments should be done by qualified personnel only. Safety checks should be

performed at regular intervals or in accordance with local and governmental regulations.

WARNING: ELECTRICAL SHOCK AND FLAMMABILITY HAZARD - BEFORE CLEANING

THE PULSE CO-OXIMETER, ALWAYS TURN IT OFF AND DISCONNECT

THE POWER CORD FROM THE AC POWER SUPPLY.

The Masimo Rainbow SET

Radical-7 Pulse CO-Oximeter is a reusable instrument. The

instrument is supplied and used non-sterile.

Cleaning

The outer surface of the Masimo Rainbow SET

Radical-7 Pulse CO-Oximeter can be cleaned

with a soft cloth dampened with a mild detergent and warm water solution. Do not allow liquids

to enter the interior of the instrument. The outer surface of the instrument can also be wiped

down using the following solvents: Cidex Plus (3.4% Glutaraldehyde), 10% Bleach, and 70%

Isopropyl Alcohol.

■ DO NOT AUTOCLAVE, PRESSURE STERILIZE, OR GAS STERILIZE THE

PULSE CO-OXIMETER.

■ DO NOT SOAK OR IMMERSE THE PULSE CO-OXIMETER IN ANY LIQUID.

■ USE THE CLEANING SOLUTION SPARINGLY. EXCESSIVE SOLUTION CAN FLOW INTO

THE PULSE CO-OXIMETER AND CAUSE DAMAGE TO INTERNAL COMPONENTS.

■

DO NOT TOUCH, PRESS, OR RUB THE DISPLAY PANELS WITH ABRASIVE CLEANING

COMPOUNDS, INSTRUMENTS, BRUSHES, ROUGH-SURFACE MATERIALS, OR BRING

THEM INTO CONTACT WITH ANYTHING THAT COULD SCRATCH THE PANEL.

■ DO NOT USE PETROLEUM-BASED OR ACETONE SOLUTIONS, OR OTHER HARSH

SOLVENTS, TO CLEAN THE PULSE CO-OXIMETER. THESE SUBSTANCES ERODE

THE INSTRUMENT’S MATERIALS AND INSTRUMENT FAILURE CAN RESULT.

Refer to Section 8, Cleaning and Reuse of Masimo Sensors for cleaning instructions of the sensor.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 115 116

Brak uwag

Masimo Radical Signal Extraction Instrukcja Operatora Strona 105